Running Water Bladder 2L
to replace your old water bladder.Try the new fastening system!
very wide fastening / opening system
Teat locking mechanism
Film : 70.0% Ethylene Vinyl Acetate (EVA), 30.0% Polyethylene (PE) Tube : 100.0% Thermoplastic polyurethane (TPU) Handle : 100.0% Polycarbonate (PC) Sliding bar : 60.0% Ethylene Vinyl Acetate (EVA), 40.0% Polyethylene (PE) Teat : 100.0% Styrene Ethylene Butadiene Styrene (SEBS) On/Off System : 100.0% Polyethylene (PE) Tube/Valve Connector : 100.0% Polyethylene (PE) Film/Tube Connector : 60.0% Ethylene Vinyl Acetate (EVA), 40.0% Polyethylene (PE)
Empty the air from your water bladder. Shocks while running shake the rucksack and water pouch. If there is air in the water pouch, you will hear the water splashing throughout your run. To avoid this disturbance, make sure that you remove the air when filling the pouch. Turn upside down and let the air go up to the tube, then suck it out. Silence once more!
Designed to :
runners wanting to hydrate easily during a workout.
empty water from bladder, clean it with dish washing liquid and rinse thoroughly, dry all elements while taking care to unscrew the tube. Do not put in dishwasher.
do not leave water in the bladder more than 24 hours. Rinse carefully with fresh water after use and leave to dry before storage.
-20°C< t°C water <+40°C. No milk/alchohol. Not microwave safe.
38cm X 18cm
100cm - you can cut it to the required length
You may also be interested in these products
* The prices listed on the site are the prices recommended by DECATHLON SA's central purchasing department.